Radio reception, Storing preset radio stations, Automatic preset programming – Philips FWI1000 User Manual
Page 25: To stop storing the automatic preset, Storing preset radio stations -26, A ® e
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

Radio Reception
©
©
(i)
(D
@
®
®
@ ® ®
o ® o
0'©'©
® C35
a ® e
o'o"© o
Storing Preset Radio Stations
You can store up to 40 preset radio stations in
the memory.
Automatic Preset Programming
EASY SET setting (refer to "Basic Functions -
EAST SET").
OR
Press TUNER (FM-AM) to select TUNER
mode.
"FLIHEf?" will be displayed. A few seconds
later the current radio frequency will appear on
the display
-» If an FM station Is received in stereo,
stereo
will appear on the display
To begin automatic preset from a desired
preset number
Press W or H (or Digits 0-9 on the remote
control) to select the desired preset number
If a radio station has been stored in one of
the presets, it will not be stored again under
another preset number
Press and hold PROG until "REIfu" appears on
the display
-> PROGRAM
will start flashing.
-» The system will start searching for all radio
stations on the FM band, then the AM band.
-> All available radio stations with sufficient signal
strength will be stored automatically.
The system will stop searching when all the
available radio stations are stored or when the
memory for 40 preset radio stations is used.
-> The last preset radio station will then be
played when completed.
To stop storing the automatic preset
• Press PROG or ■ on the system.
Note;
— If no preset number is selected, automatic preset
will begin from preset (1) and all your former
presets will be overridden.
Manuai Preset Programming
1
Press TUNER (FM* *AM) repeatedly to select
the desired waveband : FM or AM.
2
Press PROG.
->
PROGRAM
will Start flashing.
The next available preset number will be
displayed for selection.
3
Press and hold
4^
or
►►
until the frequency
indication starts to change, then release.
-> The display will show "5ERÌ7CH" until a radio
station with sufficient signal strength is found.
To store the radio station to another
preset number
•
Press N or ►! (or Digits 0-9 on the remote
control) to select the desired preset number
4
Press PROG again to store the radio station.
->
PROGRAM
will disappear from the display.
•
Repeat steps 2-4 to store other preset radio
stations.
Tuning to a weak radio station
•
Press -44 or ►► briefly and repeatedly until the
optimal reception is found.
To stop storing the manuai preset
•
Press ■ on the system.
25