Philips FWI1000 - Manual (Page 10)

Preparations
Speakers Connection
Front Speakers
Connect the speaker wires to the SPEAKERS
(FRONT) terminals, right speaker to "R" and left
speaker to "L", colored (marked) wire to " +"
and black (unmarked) wire to " —",
e Fully insert the stripped portion of the speaker
wire into the terminal as shown.
Notes:
— To avoid magnetic interference to PC monitor/TV,
do not position the front speakers too close to them.
- For optimal sound performance, use the
supplied speakers.
- Do not connect more than one speaker to any
one pair of +/ — speaker terminals.
— Do not connect speakers with an impedance
lower than the speakers supplied. Please refer to
the SPECIFICATIONS section of this manual.
) Internet Audio Connection
Use the supplied ethernet cable to connect the
RJ45 terminal to the data port on the wall
socket. Fully insert the head of the cable into
the data port.
I PC Connection
For streaming MP3 music from your PC via LAN
(Local Area Network), you must connect the
system with your personal computer Use a
network router (not supplied) to share the
internet access.
Optional Connections
The optional equipment and connecting cords
are not supplied. Refer to the operating
instructions of the connected equipment for
details.
Line Out Connection
Connect this output to any analog audio
equipment for playback or recording (CD
recorder tape recorder or amplifier for example).
Use a cinch cable to connect the LINE OUT
terminals to the analog audio in terminals of the
equipment
Connecting other equipment to your
system
Connect the audio left and right OUT terminals
of a Tv(VCR, Laser Disc player DVD player or
CD Recorder to the AUX/CDR IN terminals.
Notes:
- Do not connect equipment to both the LINE
OUT and AUX/CDR IN terminals at the same time.
Otherwise, noise will be generated and malfunction
might occur.
- If you are connecting equipment with a
monaural output (a single audio out terminal),
connect it to the AUX/CDR IN left terminal.
Alternatively, you can use a "single to double" cinch
cable (still be monaural sound).
Subwoofer Out Connection
Connect the subwoofer to the SUBWOOFER
OUT terminal. The subwoofer reproduces just
the low bass sound effect (explosions or the
rumble of spaceships, for example).
Digital Out Connection
Connect this digital output when recording on
any audio equipment with digital input (CD
Recorder Digital Audio Tape [DAT] deck. Digital
to Analog Converter and Digital Signal Processor
for example). Use a coaxial cable to connect the
DIGITAL OUT terminal to the digital input
terminal of the equipment
Inserting batteries into the
Remote Control
Insert two batteries
(type R06 orAA) into
the remote control with
the correct polarity as
indicated by the + and
- symbols inside the
battery compartment.
CAUTION!
- Remove batteries if they are exhausted
or will not be used for a long time.
- Do not use oid and new or different
types of batteries in combination.
- Batteries contain chemicai substances, so
dispose of them properly.
10