Cisco XR 12406 - Manual (Page 242)

Appendix B Repacking the Router
Repacking the Router
B-6
Cisco XR 12406 Router Installation Guide
OL-13831-01
Step 3 Install the angle brackets on the sides of the chassis (see Figure B-2 ):
a. Set the side of the bracket with the three screw holes against the side of the
chassis and align the holes with the holes in the side of the chassis.
b. Insert and loosely tighten the three screws you saved when the chassis was
unpacked.
c. Align the bolt holes in the angle brackets with the bolt holes in the pallet base.
d. Insert and loosely tighten the bolts to secure the brackets to the pallet base.
Step 4 Place the plastic bag cover over the router (see Figure B-1 ).
Step 5 Place the accessory kit on top of the router (see Figure B-1 ).
Step 6 Place the cardboard carton over the accessory kit and router (see Figure B-1 ).
Step 7 Secure the cardboard carton to the pallet with plastic-type straps similar to the
ones used to ship the router to you (see
Figure B-3 ).
The router is ready for shipment.