Figure 3-11, Baud to 9600, Data bits to 8 – Cisco XR 12406 User Manual
Page 106: Parity to no parity
Chapter 3 Installing the Cisco XR 12406 Router
Connecting to the Console and Auxiliary Ports
3-18
Cisco XR 12406 Router Installation Guide
OL-13831-01
Check your terminal’s documentation to determine the baud rate of the terminal
you plan to use. If your documentation does not specify settings use the following
terminal settings:
1.
Baud to 9600
2.
Data bits to 8
3.
Parity to no parity
4.
Stop bits to 2
The console port requires a straight-through RJ-45 cable.
Note
To comply with Telcordia GR-1089 NEBS standard for electromagnetic
compatibility and safety, connect all console, auxiliary, Ethernet, and BITS
interfaces only to intrabuilding or non-exposed wiring or cabling. The
intrabuilding cable must be shielded and the shield must be grounded at both ends.
Figure 3-11
PRP Console and Auxiliary Port Connections
1
Modem
4
Auxiliary port
2
Console terminal
5
Console port
3
RJ-45 Ethernet cables
–
—
70692
RX
TX
PRIMAR
Y
SLO
T-
1
SLO
T-
0
LINK
EN
RX
TX
ETH 1
ETH 0
A
UX
CONSOLE
LINK
PRIMAR
Y
EN
1
3
4
5
2