Cisco XR 12406 - Manual (Page 240)

Appendix B Repacking the Router
Tools and Equipment
B-4
Cisco XR 12406 Router Installation Guide
OL-13831-01
Tools and Equipment
You will need the following tools and equipment to repack the router for shipping:
• Router packaging kit
• ESD-preventive wrist strap
• Number 1 and Number 2 Phillips screwdrivers
• 9/16-inch wrench
• 10-mm wrench (either open-end or socket)
• Plastic carton straps and strap installation tools
Safety Recommendations
Before you begin the router repacking procedures, review the following safety
information:
• The safety recommendations listed in the “Safety and Compliance” section
on page 2-2 of this guide.
• The safety warnings listed in the Cisco publication Regulatory Compliance
and Safety Information for the Cisco XR 12000 Series Router (Document
Number 78-4347-19) that accompanied your router.
Repacking the Router
Repacking the Cisco XR 12406 router into the shipping container is presented in
the following procedure. This procedure assumes you have repacked the
accessory kit and have the anchor clips and angle brackets, bolts, screws, and
carton that were removed when the chassis was unpacked.
There are three phases in the repacking process:
1. Securing the router to the pallet base ( Figure B-2 ).
2. Reassembling the protective packaging around the router on the pallet base
(see
Figure B-1 ).
3. Strapping the entire package to the pallet base ( Figure B-3 ).