Cisco XR 12406 User Manual
Page 218
Chapter 5 Maintaining the Router
Removing and Installing a Clock and Scheduler Card, Switch Fabric Card, or Alarm Card
5-54
Cisco XR 12406 Router Installation Guide
OL-13831-01
Step 2
Grasp the card ejector levers and pivot them away from the SFC faceplate
(see
Step 3
Slide the SFC halfway out of the slot, then stop.
Step 4
Touching only the metal card carrier, use your free hand to support the bottom of
the SFC and slide the card completely out of the chassis.
•
Always place the SFC directly into an antistatic bag or other ESD-preventive
container.
•
If you plan to return the defective SFC to the factory, repackage it in the
shipping container you received with the replacement card.
Step 5
Set both edges of the SFC carrier into the card slot carrier alignment grooves on
either side of the SFC slot and slide the card halfway into the chassis.
Step 6
Pivot the ejector levers outward away from the faceplate.
Step 7
Slide the card into the SFC slot until the ejector levers make contact with the front
of the card cage, then stop.
Step 8
Pivot the ejector levers toward the faceplate until the connector properly seats in
the backplane.
Step 9
Tighten the two captive screws.
Caution
Do not overtighten the captive screws; over tightening can strip the
threads on the screw or in the insert in the SFC faceplate.
Verifying the Installation of the Switch Fabric Card
To verify router operation after installing a replacement SFC, see the
.