Cisco XR 12406 - Manual (Page 127)

3-39
Cisco XR 12406 Router Installation Guide
OL-13831-01
Chapter 3 Installing the Cisco XR 12406 Router
Manually Booting the System
RP Interfaces Using the RP LEDs
The Cisco XR 12000 Series Router uses the performance route processor
(PRP-2).
Note When not explicitly specified, this publication uses the term route processor (RP)
to indicate the PRP.
The RJ-45 port LEDs on the RP indicate the following conditions:
• System and RP status
• Which Flash memory card slot is active
• Which Ethernet connection is in use
• What is occurring on the Ethernet interface
The alphanumeric LED displays indicate a successful RP boot.
RP
UP
A valid Cisco IOS XR image is running. RP IOS
XR
software
PRI
RP
The RP is enabled and recognized as the system primary.
A valid Cisco IOS XR image is running. RP IOS
XR
software
SEC
RP
The RP is enabled and recognized as the system
secondary. A valid Cisco IOS XR image is running. RP IOS
XR
software
1. The version of MBus microcode running on your system might be different.
Table 3-7 LED Display Meaning and Signal Source (continued)
LED
Display
Meaning Source