Cisco XR 12406 - Manual (Page 108)

Chapter 3 Installing the Cisco XR 12406 Router
Installing a Flash Memory Card
3-20
Cisco XR 12406 Router Installation Guide
OL-13831-01
Installing a Flash Memory Card
By default, a Flash memory card ( Figure 3-12 ) containing a valid Cisco IOS XR
software image is inserted in PCMCIA slot 0 before the router is shipped.
PCMCIA slot 0 (SLOT-0) is the bottom slot and slot 1 (Slot-1) is the top slot. Both
Flash memory card slots on each RP can be used at the same time.
The software configuration register is set to 0x0102, which causes the router to
boot automatically from the Cisco IOS XR software image stored on the Flash
memory card.
Table 3-2 PRP Auxiliary Port Signals
Auxiliary Port Pin Signal Input/Output Description
1 RTS Output Request To Send
2 DTR Output Data Terminal Ready
3 TxD Output Transmit Data
4 GND — Signal Ground
5 GND — Signal Ground
6 RxD Input Receive Data
7 DSR Input Data Set Ready
8 CTS Input Clear To Send