Juniper Systems Allegro CX and CE Bluetooth CF Card - Manual (Page 13)

Bluetooth Card Installation Instructions 13
The two devices create secret codes called passkeys used to uniquely
identify each other. They use these secret codes for both security,
and establishing a unique connection to the bonded (paired) device,
even if another of the same type of device is within range. To set
up a bond between your Allegro and remote device, complete the
following steps:
Tap on the device you want to create a bond with so it is
highlighted.
Tap on Device | Bond.
Follow the instructions presented in the Bonding Wizard.
Note: To set up a bond between the Allegro and another Bluetooth
device, the device must appear in the Bluetooth device manager screen. If it
does not, a device discovery must be performed to locate the device you want
to bond to.
The Bonding Wizard requires a Bluetooth Passkey to establish
verifi cation and security features embedded within the Bluetooth
protocol. Some devices allow you to choose your own Passkey. If this
is the case, then the Passkey you enter in the bonding process must
be the same as the passkey entered in the device discovery process.
1)
2)
3)
‡