Juniper Systems Allegro MX User Guide - Manual (Page 12)

12
Field PC Owner’s Manual
This chapter teaches you about the rechargeable NiMH battery
pack. It typically lasts 12 to 20 hours, and charges in 4–6
hours using a wall charger, vehicle charger (optional), or USB/
PowerDock (optional).
Battery Settings Screen
Understanding the Battery Settings Screen
The battery charge percentage of the Field PC must be
confirmed or manually set using the Battery Settings Screen.
This screen appears whenever:
The battery pack is removed and (re)installed.
The “Power Off” option is selected from the “Power Button”
menu (which appears after holding the Power Button for 8
seconds) and then the Field PC is powered back on.
A Hard Reset is performed (by holding down the Power
Button for 10 seconds).
A Clean Boot (Set to Factory Defaults) is performed.
The charge of the battery pack is fully drained while in
the Field PC, and the unit is then plugged into an AC wall
charger or USB/Power Dock and turns on.
Note: To access the Charge Settings screen, you can either tap the
battery icon or go to Start > Settings > System tab > Power >
Charge Settings tab.




