Cyclades AlterPath BladeManager - Manual (Page 173)

Working from a CLI
AlterPath BladeManager Manual 5-11
[Enter `^Az.' to disconnect]
Re-defining the Interrupt Key
The key sequence Ctrl+C in the file /var/apm/bin/apmrun.sh has been
changed to Ctrl+_ (that is: ^_) to prevent the system from directing this
command to any application running on the foreground rather than to the
console server. Unlike ^C, the latter is not a valid key combination for most
servers including Sun, and should enable you to interrupt the console server as
necessary.
If, however, you need to re-define the command, you may do so from the
apmrun.sh file as shown:
/var/apm/bin/apmrun.sh
# Redefine CTRL+C here. Customize it as you wish.
stty intr ^_
Changing the Number of Lines in the SSH Applet
By default, the number of lines used by the memory buffer when a user scrolls
the window is set to 1000 lines (Terminal buffer = 1000). You may change
this value to suit your needs. Be aware, however, that specifying values
greater than 1000 can degrade scroll performance.
To configure the number of lines:
1. Edit the file: /opt/tomcat/apm/applet.conf
2. Locate the line and edit as follows:
Terminal.buffer = [number of lines]
3. Type in saveconf to save your configuration.
4. Close and reopen the applet window to make the change effective.
Changing the Session Timeout
The default session timeout value is 60 minutes. To change this value, follow
the steps below:
1. Edit the file: /opt/tomcat/apm/WEB-INF/web.xml
2. Locate and edit the line: