Cyclades AlterPath BladeManager - Manual (Page 37)

Installation Procedures
AlterPath BladeManager Manual 2-13
it back into its package; do not place the device on your server or on a
metal surface.
• Take extra care when handling devices during cold weather as heating
reduces indoor humidity and increases static electricity.
Installation Procedures
This section provides the following procedures:
• Installing DIMMs
• Installing a Simple-Swap Serial ATA Hard Disk Drive
• Installing a SCSI Hard Drive
• Installing an Adapter
• Completing the Installation
Installing DIMMs
When installing dual inline memory modules (DIMMs), consider the
following information and guidelines:
• Your server supports 256 MB, 512 MB, and 1 GB DIMMs, for a
maximum of 4 GB of system memory.
• Depending on the server configuration, the installation will reduce the
amount of usable memory. A certain amount of memory must be reserved
for system resources. The BIOS displays the total amount of installed
memory and the amount of configured memory.
• Your server comes with one 512 MB DIMM installed in DIMM
connector 1. If your system has one DIMM installed, when you install an
additional DIMM, you must install it in DIMM connector 3, and it must
be the same size, speed, type, and technology as the DIMM installed in
DIMM connector 1. You can mix compatible DIMMs from various
manufacturers.
• If you install a second pair of DIMMs in DIMM connectors 2 and 4, they
do not have to be the same size, speed, type and technology as the
DIMMs installed in DIMM connectors 1 and 3. However, the size, speed,
type and technology of the DIMMs you install in connectors 2 and 4 must
match each other.
• Install only 2.5 V, 184-pin, double-data-rate (DDR), PC2700 or PC3200,
unbuffered synchronous dynamic random-access memory (SDRAM)