Philips STU811 - Manual (Page 7)

J
INTRODUCTION
Ori'Screen Menus
You can operate this receiver very easily using a simple menu structure which you
access by pressing the MENU key on the handset. The whole structure and each
menu are described in detail in this manual.
Menu Languages
This product has been designed so that you can have the on-screen menus in English
or German. If, when you press the MENU key to enterthe menu system, you find that
the menus are not in your desired language, press the 8 key, then the 7 key and finally
press either the blue + or the red - on the rocker key directly below the MENU key. This
will cause the menu language to change.
Programmes
You can set up 199 “programmes”, each programme containing information about a
particular satellite channel, such as its name, frequency etc. When it is new, your
receiver has already been programmed with most of the satellite channels. See the
list supplied separately. Using the Programme Edit and Programme Install Menus you
can alter the programmes and set up new programmes for additional satellite
transmissions that you tune in to.
INSTALLATION OVERVIEW
We recommend that a qualified satellite TV installation engineer carries out the
installation of your satellite system. If, however, you install it yourself, proceed as
follows:
Connecting Up
Do not plug your receiver into the mains straight away.
Refer to the installation procedures on page 22 to make all the necessary connections
and then plug the receiver into the mains.
Tuning In
Refer to the UHF Tuning section overleaf, and make all the necessary adjustments
until the Global Settings Menu appears on your TV screen.
Antenna and LNC Settings
At the Global Settings Menu, press the 3 key to select the Antenna Settings Menu.
Refer to the procedures starting on page 20 to set up your receiver to be compatible
with your antenna and its LNC.
Viewing Programmes
When you have finished setting up, abandon the menu by pressing the OFF key. If you
have installed your receiver successfully, you can now view all the programmes which
have been pre-programmed into it at the factory.
Handset Overview
Before you start to alter the programmes or set up new ones, we recommend that you
learn howto select the existing programmes and familiarise yourself with the handset
keys (see also overleaf).
Important:
To set up your handset so that it controls only your satellite receiver, press the
SAT key once.
To set up your handset so that it controls only a PHILIPS TV set, press the TV
key once.
At any time you can use the VCR keys on your handset to control a PHILIPS VCR.
Switching In and Out of Standby Mode
Standby mode is shown by a dash on the receiver's front panel display.
To bring it out of standby mode, press one of the 0-9 keys or the P+ or P- key.
To put the receiver into standby mode, press the (!) key.
INTRODUCTION
J
(