Philips STU811 - Manual (Page 24)

INSTALLATION
I
INSTALLATION
Important:
• Do not turn on the power to your receiver, TV, VCR etc. until you have made the
necessary cable interconnections.
• These instructions and diagrams show the UHF (TV) aerial connected to the
receiver (i.e. looped-through the receiver). If you install it in this way, you should
put the receiver into standby, rather than power it off, when it is not in use,
otherwise you will not be able to view terrestrial TV programmes.
• You can connect the UHF aerial directly to the TV or VCR if you connect your TV
to your receiver using a SCART lead.
• When you have carried out one of the installation schemes described below, refer
to the Global Settings Menu section on page 19 of this manual. The LNC
Installation Menu contains a FIND SATELLITE option which can be used to help
in the positioning of the dish antenna.
• If the receiver is connected to the TVA^CR using coaxial cable, stereo sound will
not be available from your TV.
• If there is a short-circuit in the cable which connects the LNC to your receiver, the
receiver will not work and may generate clicking noises.
Connecting to a TV Using Coaxiai Cabie
Connect the cable from the dish antenna to the LNC socket on the rear panel of the
receiver.
Connect the UHF (TV) aerial to the AERIAL socket on the receiver.
Connect a coaxial cable from the TV socket on the receiver to the aerial socket on your
TV.
J
Connecting to a TV and a VCR Using Coaxiai Cabie
Connect the cable from the dish antenna to the LNC socket on the rear panel of the
receiver.
Connect the UHF (TV) aerial to the AERIAL socket on the receiver.
Connect a coaxial cable from the TV socket on the receiver to the aerial socket on your
VCR.
Connect a coaxial cable from the TV socket on your VCR to the aerial socket on your
TV.
22