Philips STU811 - Manual (Page 15)

J
Setting Up Further Timerblocks
Select the TIMERBLOCK option and press the + key to set it to 2.
As soon as you do this the start and stop times will reset themselves to the receiver's
current time. Enter the start and stop times, day and programme information required
for the second timerblock. Press the 8 key followed by the + key or - key to turn the
timer to ON for the second timerblock.
Continue in this manner until you have set up all the timerblocks you require and then
leave the menu.
When you leave the menu and put the receiver into standby mode, the timer (t)
display on the receiver’s front panel will be lit until the recording has finished.
If any of the recording times conflict with each other, they are detected and the
message TIMERBLOCK OVERLAP is displayed on the screen for a short time.
If you wish to rectify the overlap, re-enter the menu and correct the appropriate start
and/or stop times. If you do not rectify it, the end of the overlapped timerblock will be
lost.
Cancelling Timerblocks
If you decide you no longer want to record one of the programmes that you set up
in the Timer Menu, you can turn off the appropriate timerblock.
Enter the Timer Menu and select the timerblock you wish to cancel, then press the
8 key followed by the + key or - key to turn the timer OFF.
To cancel during the recording of a timerblock, press the (!) key quickly followed by
the OFF key.
OPERATION
J
PARENTAL CONTROL MENU
Important:
• The menu is shown right. If the programme/menus are currently unlocked, the
menu will read LOCK PROGRAMME/MENUS. If they are currently locked, it will
read UNLOCK PROGRAMME/MENUS and there will be the message MENUS
LOCKED at the bottom of the Parental Control Menu and the Main Menu.
• In this menu you need to key in your personal identification number (PIN). You only
have a short time to enter the 4 digits. If you do not enter them within this time, the
receiver will revert to normal viewing mode, briefly displaying the programme
number and name (if named) at the top of the screen as it does so.
• If, at any time, you key in the wrong PIN, the message NOT VALID PIN appears
and you will have to try again.
• The value of the factory set PIN (as in a new receiver) is given on page 25.
We recommend that you customise your PIN, as described in the section
Changing the PIN overleaf, rather than use the factory set value.
Locking a Programme
To lock a programme, select the programme, display the Parental Control Menu, then
press the 1 key.
The message TO LOCK PROGRAMME ENTER PIN: appears on the screen with the
programme number and name (if it is named) displayed above it.
Key in your PIN.
If you have entered the correct PIN, the message PROGRAMME LOCKED appears
on the screen; if you have entered an incorrect PIN, the message NOT VALID PIN
appears.
The programme you have just locked will remain on screen so that you can continue
viewing, but if you leave this programme and go to another, you will not be able to
return to your locked programme unless you key in your PIN.
If you try to select a locked programme, the message PROGRAMME LOCKED
ENTER PIN: appears.
Key in your valid PIN and the programme will appear on the screen.
(
PAREIMTAL CONTROL
1 (UN)LOCK PROGRAMME
S [UNJLOCK MENUS
3 CHANGE PIN
P11 VOX
TO (UN]LOCK PROGRAMME
ENTER PIN:
13