Philips FW 795W/37 - Manual (Page 9)

GENERAL INFORMATION
General Information
• The typeplate (which contains the serial
number) is located at the rear of the system.
• Recording is permissible if copyright or other
rights of third parties are not infringed.
• This device complies with part 15 of FCC rules.
Operation is subject to the following two
conditions:
- This device may not cause harmful
interference, and
- This device must accept any interference
received, including interference that may
cause undesired operation.
Environmental Information_______________
All unnecessary packaging material has been omitted.
We have done our utmost to make the packaging easily
separable into three mono-materials; cardboard (box),
polystyrene foam (buffer) and polythene (bags, protective
foam sheet).
Your system consists of materials w/hich can be recycled
and reused if disassembled by a specialized company.
Please observe the local regulations regarding the
disposal of packaging materials, exhausted batteries and
old equipment.
Acknowledgement
□□
DOLBY SURROUND
PRO LOG
Dolby Pro-Logic and the double-D symbol 00 are
trademarks of Dolby Laboratories Licensing Corporation.
Manufactured under license from Dolby Laboratories
Licensing Corporation.
Accessories (Supplied)___________________
- Remote control
- Batteries (2 x AAA size) for remote control
- AM loop antenna
- FM antenna wire
- AC power cord
- Philips Magnavox FB 209W wireless surround speaker
package (includes 2 x wireless surround rear speakers
and 1 X center speaker and a transmitter unit).
SAFETY INFORMATION
Safety Information_______________________ ^
• Before operating the system, check that the operating ^
voltage indicated on the typeplate (or the voltage
indication beside the voltage selector) of your system
is identical with the voltage of your local power
supply. If not, please consult your dealer. The type
plate is located at the rear of your system.
• When the system is switched on, do not move it
around.
• Place the system on a solid base (e.g. a cabinet).
• Place the system in a location with adequate
ventilation to prevent internal heat build-up in your
system.
• Do not expose the system to excessive moisture, rain,
sand or heat sources.
• Under no circumstances should you repair the system
yourself, as this will invalidate the warranty!
• If the system is brought directly from a cold to a warm
location, or is placed in a very damp room, moisture
may condense on the lens of the CD unit inside the
system. Should this occur, the CD player will not
operate normally. Leave the power on for about one
hour with no disc in the system until normal playback
is possible.
• Electrostatic discharge may cause unexpected
problems. See whether these problems disappear if
you unplug the AC power cord and plug it in again
after a few seconds.
• To disconnect the system from the power supply
completely, remeve the AC power plug from the
wall secket.