Philips FW 795W/37 - Manual (Page 22)

TUNER
I
1 ~ T U N E R
Easy Set fon/yin Standby or Demonstration mode) * •
EASY SET allows you to store all available radio stations
in a particular band (FM»AM) automatically.
• Press and hold STANDBY»ON (on the system only)
for 2 seconds.
— THSy EiET" will be displayed and followed by
"TUrCR".
— Easy set will start with the last active band.
— All available radio stations with sufficient signal
strength will be stored or until up to 40 presets are
filled.
Notes:
- When EASY SET is used, all previously stored stations
will be erased.
- The last preset station will appear on the display
when Easy Set is completed.
Tuning to Radio Stations
Press TUNER to select TUNER mode.
-> "TUfJER" will be displayed.
— The preset number, frequency and waveband
appear on the display.
Press TUNER (BAND) again to select the desired
waveband : FM or AM.
Press TUNING or ►► for more than one second,
then release.
The display will show "SERRCfT' until a radio
station with sufficient signal strength is found.
Repeat this procedure until the desired radio station is
reached.
To tune to a weak station, briefly press TUNING
or ►► until the display shows the desired frequency
and/or when the best reception has been obtained.
Storing Preset Radio Stations____________
You can store up to 40 radio stations in the memory.
When a preset radio station is selected, the preset
number appears next to the frequency on the display.
Automatic programming
1
Press TUNER
2 Press TUNER (BAND) again to select the desired
waveband : FM or AM.
3 Press PROGRAM for more than one second.
— PROGRAM flag starts flashing and 'RUTO' will be
displayed.
Every available radio station will be stored
automatically. The frequency and preset number
will be displayed briefly.
— The system will stop searching when all the
available radio stations are stored or when the
memory for 40 preset radio stations is used.
— The system will remain tuned to the last stored
preset radio station.
• Repeat the above procedure to store other preset
stations for the other waveband. Remember to select
the next available preset number before proceeding. If
not, some of the preset radio stations may be erased.
Notes:
- You can cancel the automatic programming by
pressing PROGRAM or STOP ■.
- If you want to reserve a section of preset numbers, for
example preset numbers I to 9, select preset 10
before starting automatic programming: now only the
preset numbers 10 to 40 will be programmed.
22