Philips FW 795W/37 - Manual (Page 27)

RECORDING
CD Synchro Start Recording
One Touch Recording
For One Touch Recording, as soon as you press
RECORD, the current source will be recorded on tape
deck 2.
1 Load a blank tape in tape deck 2.
2 Press RECORD to start recording.
— REG flag starts flashing.
3 Press STOP« to stop recording.
Note:
When you press RECORD at TAPE mode, ’SilLETI i
QTMEf? EDuRCE'will be displayed. One Touch
Recording Is not possible at TAPE mode.
CLOCK
Load a blank tape into tape deck 2 and a disc into the
disc tray.
Press CD to select CD mode .
You can program the tracks in the order you want them
to be recorded (see Programming Tracks). If not, the
tracks are recorded according to the selected disc.
Press RECORD to start recording.
REC flag starts flashing.
CD will start playback automatically.
Press STOP ■ to stop recording.
View Clock
You can view the clock (if it is set) at standby or any
source mode. It will be displayed for about 7 seconds.
Press CLOCK'TIMER briefly
— " IQ:SS AM" (the current time) will be displayed.
— " will be displayed if the clock is not set.
Clock setting
The clock is set in 12-hour mode, e.g. tc'DJO AM or
lE'.ElD PM. Before setting the clock, you must be in the
View Clock mode.
2 Set the hour with ◄◄ or ►>.
3 Set the minute with M or M .
4 Press CLOCK*TIMER again to store the setting.
— The clock starts running.
• To exit without storing the setting, press STOP ■ .
Notes:
- During clock setting. If no button is pressed within 90
seconds, the system will exit clock setting mode
automatically.
- When power Interruption occurs, the clock setting is
erased.
1 Press CLOCK»TIMER to select clock mode.
— " I a': [I [I AM" or the current time starts flashing.
(◄.►I,« " light up.
27