Philips FW 795W/37 - Manual (Page 26)

RECORDING
етдрдаг-ом 1
■Q
RECORD
REVERSE MODE \
# \
f
IT IS RECOMMENDED THAT YOU SWITCH OFF
DOLBY PRO LOGIC WHEN RECORDING.
Notes:
- For recording, use only tape of I EC type I (normal tape)
orlEC type II (Chrome).
- The tape Is secured at both ends with leader tape. At
the beginning and end of tape, nothing will be
recorded for six to seven seconds.
- The recording level is set automatically, regardless of
the position of VOLUME, DBB or Incredible Surround.
- To prevent accidental recording, break out the tab on
the left shoulder of the tape side you want to protect
- If THECK T ЯРЕ "is displayed, the protection tab
has been broken. Put a piece of clear adhesive tape
over the opening. Do not cover the CrO^ tape detection
hole when covering the tab opening.
Recording from other sources (only on tape
decks)
1 Press TAPE to select tape deck 2.
2 Load a blank tape into tape deck 2 with the open side
downward.
3 Press SIDE on remote control to select the recording
side.
-* * T h e o r ► (back or front) flag will be displayed,
depending on the side selected.
4 Press REVERSE MODE to select the playback mode
(Zorz:))-
5 Press CD, TUNER or AUX
• Start playback of the selected source.
6 Press RECORD to start recording.
— REC flag starts flashing.
7 Press STOP ■ to stop recording.
Notes:
- Only or mode is available during recording.
- During recording, it is not possible to listen to another
source.
Dubbing tapes (from tape deck l to tape decks)
1 Press TAPE to select tape deck 2 .
2 Load the prerecorded tape into tape deck 1 and a
blank tape into tape deck 2.
— Make sure that the tape in tape deck 1 has its full
spool to the left.
3 Press SIDE on remote control to select the recording
side.
4 Press DUBBING once for normal speed dubbing or
twice within S seconds for high speed dubbing.
"PuPt'IPL" (normal speed) or TR5T" (high speed)
will be displayed and then followed by
"HilSSIPB".
— HSD flag appears on the display for high speed
dubbing.
• Dubbing will start immediately.
REC flag starts flashing.
5 Press STOP ■ to stop dubbing.
Notes:
- At the end of side A, flip the tapes to side B and
repeat the procedure.
- Dubbing of tapes is only possible from tape deck 1 to
tape decks.
- To ensure good dubbing, use tapes of the same length.
- During high speed dubbing In Tape mode, the sound is
reduced to a low volume.
- You can switch to other source while dubbing.
26