Philips CCZ194AT - Manual (Page 8)

8 Turning On the TV/YCR
Before you turn on theTV/VCR, make sure there are batteries in
the remote control and theTV/VCR is hooked up correctly.
The instructions on this page work only when you turn on the
TV/VCR for the first time.
Press the POWER button.
The TV/VCR will come on and the
screen shown below will appear.
SELECT LANGUAGE \
> ENGLISH ON
ESPAÑOL
SELECT AT OR
PRESS MENU TO CONTINUE
2
Press the PLAY/ a button or the STOP/T button to select
English or Spanish on-screen displays.
3
Press the MENU button.
The screen shown below will appear.
' CONNECTAr'iTHMslA OR CABl£
TOTVCR
THEN PRESS I
TO END PRESS EXIT
4
Press the F.FWD/^ button to begin automatic channel
setup.
The TV/VCR will memorize all available channels. When
channels are set, CHANNELS ARE SET will appear on-screen
briefly.Then theTV/VCR will go to the lowest channel pro­
grammed.
(If you try to set up channels when there is no antenna or cable
connected to the TV/VCR, programming will appear to take place,
but eventually a NO TV SIGNALS ... message will appear on­
screen. Connect an antenna or cable to the TV/VCR, then try
again.You may need to follow the steps on page 10 instead.)
5
Use the CH(annel). Up/Down buttons or the Number but­
tons on the remote control to select a TV/VCR channel.
Use the VOL(ume). Up/Down buttons to adjust the sound.
Helpful H ints
If you do not see any on-screen dis­
plays when you turn on the TV/VCR,
check your hookups, then try again.
If you still do not see any on-screen
displays, follow the steps on pages
nine - 10 to select a language and
set up channels.
To skip step 2, press the
STATUS/EXIT button. All on-screen
displays will be in English. To skip
step 4, press the STATUS/EXIT but­
ton. Channels will not be set up, and
CHANNELS NOT SET will appear
on-screen briefly.
You cannot set up channels if you
are using a Cable Box.
Line Input mode will always be
stored in the TV/VCR’s memory as
channel 00. When you select chan­
nel 00,A/V IN will appear on-screen
briefly. Press the CH(annel).
Up/Down buttons or Number but­
tons to select another channel.