Philips CCZ194AT User Manual
Page 40
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
![background image](/manuals/680364/40/background.png)
40 Setting Up the YCR Plus* Programming System (confd)
2
..................................................................................................................
2
Examine the lists on
page 39.
Now, compare the channel numbers you have written In the VCR
PLUS+ CH. and CABLE/TV CH. columns.You'll notice that some
stations have VCR Plus+ and Cable/TV channel numbers that are
the same, and other stations have channel numbers that do not
match. Where the channel numbers DO NOT match, you must tell
theTV/VCR the VCR Plus+ and Cable/TV channel numbers
according to the following steps.
• Make each entry within 60 seconds of the previous entry.
3
Presi the COMBI button, then preis the MENU button.
4
Press the PLAY/A button or the STOP/T button to select
VCR SETUP, then press the F.FWD/^ button.
5
Press the PLAY/A button or the STOP/T button to select
VCR PLUS-i- RER MAP, then press the F.FWD/^ button.
^VCR PLUS+ CROSS REF. MAP
VCR PLUS*
CABLE/TV
124
125
01------^
02
03
TO SELECT CH PRESS AT
THEN ENTER CH NO.
V TO END PRESS EXIT
6
Look at the lists you filled in on page 39.
For stations whose
VCR Plus+ and Cable/TV channels do not match, press
the PLAY/A button or the STOP/V button until the arrow
is beside the VCR Plus+ channel you need.Then, press the
Number buttons to enter the corresponding Cable/TV
channel from your list.
(Enter a “0” before single-digit channels.)
Continue this process until you have entered all the stations on
your list.
Note: If you are using a Cable Box/DBS, the Cable/TV channel will
be 03 or 04 (the Cable Box/DBS output channel) for every VCR
Plus+ channel.You must set the Cable Box/DBS to the channel you
want to record; leave the Cable Box/DBS on for the timer record
ing.
VCR PLUS+ CROSS REF. MAP
VCR PLUS+ CABLE/TV
124
125
01 --------► 23
02
03
TO SELECT CH PRESS
AT
TO DELETE PRESS CLEAR
TO END PRESS EXIT
7
4"6
7
6
Press the STATUS/EXIT button.
Helpful H ints
To correct a Cable/TV channel num
ber, repeat the steps on this page.
To clear a Cable/TV channel num
ber, repeat steps 3-5 on this page.
Then, press the CH(annel) Up/Down
buttons to select itThen press the
CLEAR button. Press the
STATUS/EXIT button.
Always enter a “0” before single-digit
channels.
To select line input for the Cable/TV
channel, press 0,0. A/V IN will
appear on-screen.