IC Realtime 4 Channel Forensic Network Video Recorder - Manual (Page 87)

78
4.2.7.3 Alarm Output
Here is for you to set proper alarm output.
Please highlight icon to select the corresponding alarm output.
If there is any alarm, you can view at the status item.
After all the setups please click OK button, system goes back to the previous menu. See Figure
4-98.
Figure 4-98
4.2.7.4 Manual Record
Note:
You need to have proper rights to implement the following operations. Please make sure the
HDD has been properly installed.
4.2.7.4.1 Manual
record menu
There are two ways for you to go to manual record menu.
z
Right click mouse or in the main menu, Advanced->Manual Record.
z In live viewing mode, click record button in the front panel or record button in the remote
control.
Manual record menu is shown as in Figure 4-99.
4.2.7.4.2 Basic
operation
There are three statuses: schedule/manual/stop. Please highlight icon“○” to select
corresponding channel.
z
Manual: The highest priority. After manual setup, all selected channels will begin ordinary
recording.
z Schedule: Channel records as you have set in recording setup (Main Menu->Setting-
>Schedule)
z Stop: All channels stop recording.
Figure 4-99