IC Realtime Combo Series: 8 Channel DVR with built-in 10 LCD monitor - Manual (Page 138)

129
z Burner and 10.2-inch combo DVR are in the same data cable.
z System uses too much CPU resources. Please stop record first and then begin backup.
z Data amount exceeds backup device capacity. It may result in burner error.
z Backup device is not compatible.
z Backup device is damaged.
18. Keyboard can not control 10.2-inch combo DVR.
There are following possibilities:
z 10.2-inch combo DVR serial port setup is not correct
z Address is not correct
z When there are several switchers, power supply is not enough.
z Transmission distance is too long.
19. Alarm signal can not been disarmed.
There are following possibilities:
z Alarm setup is not correct.
z Alarm output has been open manually.
z Input device error or connection is not correct.
z Some program versions may have this problem. Please upgrade your system.
20. Alarm function is null.
There are following possibilities:
z Alarm setup is not correct.
z Alarm cable connection is not correct.
z Alarm input signal is not correct.
z There are two loops connect to one alarm device.
21. Remote control does not work.
There are following possibilities:
z Remote control address is not correct.
z Distance is too far or control angle is too small.
z Remote control battery power is low.
z Remote control is damaged or 10.2-inch combo DVR front panel is damaged.
22. Record storage period is not enough.
There are following possibilities:
z Camera quality is too low. Lens is dirty. Camera is installed against the light. Camera
aperture setup is not correct.
z HDD capacity is not enough.
z HDD is damaged.
23. Can not playback the downloaded file.
There are following possibilities:
z There is no media player.
z No DXB8.1 or higher graphic acceleration software.