GTCO AccuTab VI - Users Guide - Manual (Page 37)

AccuTab VI 37
Replacing the Cordless Cursor Batteries
The cordless cursor requires two AAA batteries. The average battery life for the cursor
batteries is 2,000 hours.
To replace the batteries:
1. Place the cursor face down in the
palm of your hand. Use a Phillips
screwdriver to remove the two
screws located on the bottom of
the cursor (see figure). Remove
the cursor base.
2. Remove the old batteries from the
battery casings.
3. Place the new batteries in the
casings, matching the polarity of
each battery with the markings on
the connector strips (match + to
+).
4. Reposition the cursor base.
Replace the screws with the
Phillips screwdriver.
NOTE: When you replace the cordless pen or cursor batteries, the transducer will reset to
the default frequency. If you changed the frequency of the transducer before replacing the
batteries, you will need to do so again after replacing the batteries (see Reducing Monitor
Interference in the next section).
Reducing Monitor Interference
If you are experiencing monitor interference with your tablet, you can reduce the
interference by changing the frequency your transducer uses. This can be done only for
transducers that support changing the frequency.