GTCO AccuTab VI - Users Guide - Manual (Page 11)

AccuTab VI 11
Transducer Connection
1. Connect the corded high-accuracy cursor to the appropriate jack on the digitizer’s
Connector Panel. The connector is keyed and will fit only the correct jack. Do not
force it.
USB Connection
The AccuTab VI USB port connection is USB 1.1and 2.0 compatible. When the digitizer is
connected to the USB port, Windows will recognize that there is a new device connected. If
Windows displays the Found New Hardware prompt, follow the onscreen instructions to
complete the driver installation.
1. Connect the interface cable to the USB jack on the AccuTab VI Connector Panel. The
connector is keyed and will fit only the correct jack. Do not force it. Join the other
end of the USB cable to any one of the USB ports
on your computer or USB
hub.
2. Turn the power switch on. The digitizer will beep four short tones, indicating it has
power. See the AccuTab VI Tones section of this manual for a complete table of
AccuTab VI tones.