GTCO AccuTab VI - Users Guide - Manual (Page 13)

AccuTab VI 13
tablet will beep four times. The Indicator Light will glow steadily when the transducer is
inside the Active Area of the tablet. When the transducer moves outside the Active Area,
the Indicator Light will go off.
Using the AccuSet Menu [RS-232 Only]
The AccuSet Menu is the row of buttons printed across the top of the digitizer. It allows
you to configure your AccuTab VI to send the appropriate information through an RS-232
serial connection to the software being used on the computer.
The AccuSet Menu is used to prepare the digitizer to receive specific, detailed custom
configuration information from the Tablet Configuration Utilities for some serial
installations.
In addition, for both serial and USB connections, the AccuSet Menu can be used to reset
AccuTab VI, turn the digitizer alarm off and on and test the grid or Active Area. Use the
cursor to click on the menu buttons to make your selections.
The menu button initiates Select Mode. Two-digit numeric codes are entered after
Select Mode is activated.
NOTE: Select Mode will not work with the USB interface. USB digitizers are used exclusively
with Wintab drivers.
Most software supports Wintab using the TabletWorks drivers, whose AccuSet Code is
on the AccuSet Menu. The AccuTab VI comes from the factory with the
AccuSet Code pre-configured.