GME RX1300 - Manual (Page 4)

PAGE 4 INSTRUCTION MANUAL RX1300
INSTALLING ThE ANTENNA
1. Place the antenna onto the antenna
socket on top of the radio.
2. Rotate the antenna clockwise to screw
into place.
3. Do not over tighten.
INSTALLING ThE LANyARD
1. Slide the small end loop of the
lanyard through the slot in the rear of
the receiver’s top panel.
2. Feed the large end of the lanyard
through the loop and tighten
ChARGING ThE BATTERy
Your scanner receiver is supplied with
a rechargeable battery back, desktop
charging cradle and AC adaptor.
To charge the battery:
1. Fit the battery to the receiver (see
instructions left). Ensure the receiver
is switched off.
2. Connect the AC adaptor to the
charging cradle.
3. Plug the AC adaptor into a mains
power outlet.
4. Insert the receiver into the charging
cradle until it ‘clicks’ home. The
charging LED will glow RED and
charging will begin.
If the charging LED blinks RED and
GREEN or does not light at all, remove
the receiver from the cradle and
reinsert it.
The charging time for a discharged
battery is typically 12–15 hours. When
the battery is fully charged, the LED will
turn GREEN.
Note: If you find yourself in a position
where you need to charge the battery
but the charging cradle is not available,
you can plug the AC adaptor directly
into the receiver’s charging socket
located under the accessory jack cover.
RX1300
RX1300
RX1300
RX1300
RX1300
RX1300
Charging LED