GME RX1300 - Manual (Page 14)

PAGE 14 INSTRUCTION MANUAL RX1300
To perform a Priority Search using a
frequency as the Priority Channel:
1. Enter the required Priority Channel
frequency using the Keypad then
press E/VFO.
2. Press Func PRI. The selected
frequency is now the Priority Channel.
3. Press Band/Bank to select the
require frequency band you wish
to scan.
4. Press Scan/Src. The receiver will
begin scanning the selected band and
will switch to the Priority channel at
an interval set by the ‘Priority Time’
setting in the setup menu.
5. Press FUNC PRI to deselect current
priority channel. Follow steps 1-4 to
add new priority channel.
To perform a Priority Search using a
stored channel as the Priority Channel:
1. Press Func MR to select the Memory
Read Mode.
2. Press Bank/Band to select the
required memory bank.
3. Rotate the Control Knob to select
the required channel.
4. Press Func PRI. The selected channel
is now the Priority Channel.
5. Press Band/Bank to select the
require frequency band you wish
to scan.
6. Press Scan/Src. The receiver will
begin scanning the selected band and
will switch to the Priority Channel at
an interval set by the ‘Priority Time’
setting in the setup menu.
• If a signal is received, the receiver will
remain on the active frequency for the
duration of the ‘Busy Timer’ setting
in the Menu setup. If the ‘Busy timer’
is set to Busy the receiver will stay on
the active channel for as long as the
signal is present.
• To change the frequency band while
searching, briefly press Band/Bank key.
• To change the search direction while
searching, rotate the control knob
clockwise or counter clockwise.
Dual Watch
The Dual Watch function lets you
constantly monitor two frequencies for
activity.
To set the Dual Watch function:
1. Enter one of the required frequencies
using the Keypad then press E/VFO.
2. Adjust the squelch so that the
receiver is muted.
3. Press Func DW.
4. Enter the second frequency using the
Keypad then press E/VFO.
5. The Dual watch begins automatically.
If a signal is received, the receiver will
remain on the active frequency for the
duration of the ‘Busy Timer’ setting in
the Menu setup. If the ‘Busy timer’ is
set to Busy the receiver will stay on the
active channel for as long as the signal
is present.