GME RX1300 - Manual (Page 10)

PAGE 10 INSTRUCTION MANUAL RX1300
Using the Control Knob
First select the required starting
frequency using the direct frequency
input method, then rotate the control
knob to step up or down in frequency
from the starting point. The frequency
will change in the selected
frequency step.
·
To change frequency in 1 MHz steps,
press the FUNC key, then press the
or keys to change the frequency.
(F is displayed while the ‘Func’ Mode
is active).
·
To change frequency in 10 MHz steps,
press the Func key then rotate the
control knob to change the frequency.
(F is displayed while the ‘Func’ Mode
is active).
Note: The Func Mode clears a few
seconds after the last key press or
control knob change.
Mode Selection
By default, the receiver automatically
selects the modulation Mode most
commonly used for each band (see the
Frequency Band chart for the default
Modes for each band) To manually
select a different Mode, press ‘Func’
followed by the Mode key.
Each press will step through the Mode
settings in the following order:
-> AM -> FM -> WFM (Wideband FM)
-> Auto ->
To automatically have the receiver select
the Mode for the band you are on,
select the Auto Mode.
Frequency Step Selection
By default, the receiver automatically
selects the frequency Steps most
commonly used for each band (see the
Frequency Band chart for the default
Steps for each band).
To select a different step:
1. In VFO Mode press MENU.
2. Press the Volume or keys until
STEP is displayed.
3. Turn the Control knob until the
desired frequency step is displayed.
4. Press E/VFO to confirm the selection.
The following Frequency Steps
are available:
5 kHz
6.25 kHz
8.33 kHz (108 MHz - 135.975 MHz)
9 kHz (below 1.620 MHz ONLY)
10 kHz
12.5 kHz
15 kHz
20 kHz
25 kHz
30 kHz
50 kHz
100 kHz
500 kHz
Auto