GME RX1300 - Manual (Page 19)

RX1300 INSTRUCTION MANUAL PAGE 19
MENU SETTINGS
The Menu settings will vary depending on the selected Mode.
· Press the MENU Key to access the Menu settings.
· Press the volume keys to step through the Menu items.
· Rotate the Control knob to change the values of each Menu item.
VFO Mode
FUNCTION DESCRIPTION VALUES
Delay Determines how long the radio will wait on a
frequency after a signal has disappeared while
scanning or Searching 1 -10 Seconds
Beep Activates or deactivates the keypress beeps. ON, OFF
Step Sets the Frequency Step in kHz. When Auto
is selected the receiver automatically uses a
factory preset frequency step for each band. 5, 6.5, 8.33,
9, 10, 12.5,
15, 20, 25, 30,
50,100, 500,
Auto
Memory Shows the available Manual Memory left in
the receiver 0 - 1000
Priority
Time Sets how long the receiver will wait before
visiting the selected Priority channel when
Scanning or Searching 1 – 10 Seconds
Tone Selects the required CTCSS or DCS tone.
The tone is then activated or deactivated by
pressing Func TONE See CTCSS/DCS
Table (pg18)
Busy Timer Determines how long the receiver will wait on
a busy channel while Scanning or Searching.
When ‘Busy’ is selected, the receiver will stay
on the busy channel as long as it remains busy. Busy, 5 Seconds