GME RX1300 - Manual (Page 17)

RX1300 INSTRUCTION MANUAL PAGE 17
4. Select the required channel using the
control knob.
Limited Search Memories
Here you will be storing a pair of
frequencies that represents the
upper and lower limits of a section of
frequency band you wish to search for
signals.
To store a pair of frequency limits into
the Limited Search Memories.
Here you will be storing a pair of
frequencies that represents the
upper and lower limits of a section of
frequency band you wish to search for
signals.
To store a pair of frequency limits into
the Limited Search Memories.
1. Press the E/VFO key to select
VFO Mode.
2. Press the Band key to select the
required band.
3. Enter the frequency that represents
one end of the range you wish
to search.
4. Press Func LMT. L1 will flash on
the display to indicate that you are
entering the first frequency limit.
5. Press the E/VFO key to accept. L2
will flash on the display to indicate
you are now entering the second
limit frequency.
6. Enter the second frequency limit then
press E/VFO to accept it.
7. Now press Func MW. The receiver
enters the Memory Write Mode and
selects the Pr memory bank.
8. Use the control knob to select an
empty channel to store the
frequency pair.
9. Press Func MW again to store
the frequencies.
The selected frequencies limits will be
stored as a pair of channels in locations
Axx and bxx where xx is the channel
number you selected in step 8.
To recall a frequency limit pair from the
Limited Search Memories.
1. Press the E/VFO key to select
VFO Mode.
2. Press Func MR. The receiver will
enter the Memory Read Mode.
3. Press the BANK key repeatedly to
step through the memory banks until
Pr is displayed.
4. Select the required channel using the
control knob.
5. Set the squelch level to a point where
the receiver is just quiet.
6. Briefly press SCAN/SRC. The radio
will begin scanning between the
selected frequency limits.
Dual Watch Memories
The Dual Watch memories are used to
store a pair of frequencies that will be
monitored when the Dual Watch feature
is enabled. Up to 50 frequencies
(25 pairs) can be stored.