GME RX1300 - Manual (Page 13)

RX1300 INSTRUCTION MANUAL PAGE 13
2. Set the Squelch level using the
Squelch keys so that the noise just
disappears.
3. Press Func followed by the LMT key.
[L1] is displayed.
4. Enter the First frequency using the
keypad or the control knob.
5. Press E/VFO when done. [L2]
is displayed.
6. Enter the Second frequency using the
keypad or the control knob.
7. Press SCAN SRC. The Limited Search
will begin, searching upwards from
the first frequency to the second in a
continuous cycle.
8. To stop the Search, press the SCAN
SRC key again.
• To change the Search direction rotate
the control knob clockwise or
counter clockwise.
• The receiver will stay on an active
channel according to the Scan Timer
settings in the VFO Menu. If the
Scan Timer is set to ‘5 seconds’, the
receiver will continue Searching after
5 seconds even if the channel is still
busy. If the Scan Timer is set to ‘Busy’,
the receiver will remain on the busy
frequency for as long as it stays busy,
then resume searching when the
signal disappears.
NOTE: The Limit Search always searches
upwards in frequency. If the first
frequency is lower than the second it
will search between the two frequencies.
If the first frequency is higher then the
second it will search outside the
two frequencies.
pRIoRITy SEARCh
Priority Search allows you to insert a
Priority Channel into the frequency
search. When the search is activated,
the receiver will visit the Priority channel
or frequency at an interval set by the
‘Priority Time’ in the Menu setup.
L1 is a lower frequency than L2
L1 is a higher frequency than L2
Lower Band
Edge
Lower Band
Edge
L1 L2
L2 L1
Upper Band
Edge
Upper Band
Edge
1st
Frequency 2nd
Frequency Frequencies
Searched
40 MHz 50 MHz 40 –> 50 MHz
50 MHz 40 MHz
50 –> 87.975,
30 –> 40 MHz