beautypg.com

GME RX1300 User Manual

Page 12

background image

PAGE 12

INSTRUCTION MANUAL

RX1300

4. Select a start frequency to search

from. To do this, enter the frequency

on the keypad, then press E/VFO key.

5. Press the SCAN SRC key briefly. The

‘SRCH’ icon will be displayed and the

receiver will search the selected band

starting from the start frequency.

Once the end of the band is reached

the search continues at the beginning

of the selected band.

6. To stop the search, press the SCAN

SRC key again.

• During the search, press the BANK

BAND key to move to the next band.

• To change the search direction

rotate the control knob clockwise or

counter clockwise.

• The receiver will stay on an active

channel according to the Scan Timer

settings in the VFO Menu. If the

Scan Timer is set to ‘5 seconds’,

the receiver will continue searching

after 5 seconds even if the channel

is still busy. If the Scan Timer is set

to ‘Busy’, the receiver will remain on

the busy frequency for as long as it

stays busy, then resume searching

when the signal disappears.

Full Search

The Full Search function searches the

entire scanner frequency range

for signals.

1. Press the E/VFO key to select

VFO Mode. (Note: the receiver

automatically selects the VFO Mode

when it is turned on).

2. Set the Squelch level using the

Squelch keys so that the noise

just disappears.

3. Press and hold the SCAN SRC key

for 2 seconds. The ‘SRCH’ icon will

be displayed and the receiver will

search the entire frequency range of

the receiver.

4. To stop the search, press the SCAN

SRC key again.

• During the search, press the BANK

BAND key to move to the next Band.

• To change the search direction rotate

the control knob clockwise or counter

clockwise.

• The receiver will stay on an active

channel according to the Scan Timer

settings in the VFO Menu. If the

Scan Timer is set to ‘5 seconds’, the

receiver will continue searching after

5 seconds even if the channel is still

busy. If the Scan Timer is set to ‘Busy’,

the receiver will remain on the busy

frequency for as long as it stays busy,

then resume searching when the

signal disappears.

LIMITED SEARCh

You can limit the search between two

user-selectable frequency limits.

1. Press the E/VFO key to select

VFO Mode. (Note: the receiver

automatically selects the VFO Mode

when it is turned on).