GME RX1300 - Manual (Page 16)

PAGE 16 INSTRUCTION MANUAL RX1300
SToRING FREQUENCIES
INTo ThE MEMoRIES
Manual memories
To manually store a frequency into one
of the manual memories:
1. Press the E/VFO key to select
VFO Mode.
2. Press the BAND key to select the
required Band.
3. Select the frequency that you want to
store using the number keys or the
control knob.
4. Press Func MW to enter the Memory
Write Mode.
5. The receiver will find and display an
empty memory bank and memory
location automatically.
6. If required, use the number keys to
select a new memory bank e.g. For
memory bank 16 press 1 and 6.
7. To change the memory location,
rotate the control knob.
8. Press Func MW again to store
the frequency.
To recall a frequency from the
manual memories:
1. Press the E/VFO key to select
VFO Mode.
2. Press Func MR. The receiver will
enter the Memory Read Mode.
3. To step through the memory banks
press the BANK key or enter the
memory bank directly using the
numbered keys. Memory banks are
numbered 00 to 39.
4. Select the required channel using the
control knob.
Automatic Memories
The Automatic Memory holds
frequencies that are stored automatically
while doing a Band Search.
To store frequencies into the
Automatic Memories:
1. Press the E/VFO key to select
VFO Mode.
2. Select the band and frequency that
you wish to begin searching from.
3. Set the Squelch level to a point where
the receiver is just quiet.
4. Press Func AW to select the
Automatic Write Mode.
5. Press the Bank key to select the
required memory bank (A0 or A1).
6. Press the SCAN/SRC key to
begin scanning.
7. As active frequencies are found they
are automatically stored in the select
memory bank. When all 100 channels
are fully stored the receiver will Beep.
8. To exit from the Automatic memory
Mode, press the E/VFO key.
To recall frequencies from the
Automatic Memories:
1. Press the E/VFO key to select
VFO Mode.
2. Press Func MR. The receiver will
enter the Memory Read Mode.
3. Press the BANK key repeatedly to
step through the memory banks until
A0 or A1 are selected.