Philips CCZ192AT - Manual (Page 47)

Sf>ecification$ / Glossary 47
Specifications
General
CRT; 19-inch in line gun
Television system: NTSC-M
Closed caption system: Section 15.1 f 9, FCC
(Federal CcHTimunications Commissicm) Standard
Video Heads:Tvro heads
Tape wiidth; 1/2 inch (12.65 mm)
Tape speed
SP; 33.35 mm/sec.
LP: 16.67 mm/sec.
SLP: 1 1 . 1 2 mm/sec.
Operating1emperature;4rF (S°C) to I04‘F (40'C)
Relative Humidity: 10% to 75%
Power requirement: AC l20V,60Hz
Power consumption: 90W
Sound output: IW
Dimensions:
19-11/16" (H) X 19-7/16" (W) X 18-5/16" (D)
500mm x 494mm x 465mm
Weight 44,1 lbs (20 kg)
Tuner Broadcast Channels
V H F 2 - I 3 . U H F 14-69
Cable TV Channels
Midband;A- I
Superband: J -W
Hyperband: A-5 - A - 1
Special Channel: 5A
Ultraband: 37 - 9 4 . 1 0 0 - 1 2 5
Terminals
Antenna IN:VHF/UHF 75 ohms unbalanced
Video IN: RCA connector
Audio IN: RCA connector
Earphone: 3.5 mm CES
Electrical Specifications
Video input level; 0.5-2.0Vp-p
Audio input level:-IOdBv
Video S/N ratio
SP: More than 42dBp
Audio S/N ratio
SP: More than 38dB
Designs and specificot/ons ore subject to change without
notice and without our lega/ obligation.
Glossary
AUDIO lack; jack located on the front of the
TV/VCR which is used to record audio from anoth- ‘
er source.
Automatic Channel Setup: process in which the
TV/VCR scans all available channels and places the
ones you receive in its memory.Then, when you
push the CHANNEL buttons, you only scan
through channels you receive.
Bands: settings that allow you to tune channels.
• Antenna - VHP (very high frequency; channels 2
- 13) and UHF (ultra high frequency, channels 14 -
69).
• Cable — all standard channels can be received
without a Cable Box.
Brightness: adjusting increases or decreases the
brightness of the color on-screen.
Color, adjusting pales or bri^tens the TV/VCR color.
Dubbing: copying a tape using aVCR.
HQ: high quality; a feature in the TV/VCR circuitry
which provides enhanced picture detail.
Line Input: The channel to which you set your
TV/VCR during dubbing.The line input channel is
always channel 00 (A/V IN).
Mode: a TV/VCR operation.
em One-Touch Recording; programming a timed
recording that starts immediately and records for
30 minutes to eight hours, whichever you specify.
Picture: adjust to increase or decrease the con­
trast of the picture on-screen.
Sharpness: adjusting softens or clarifies the picture
on-screen.
Tape Speeds: how hist the tape travels during
pityback or recording.
• SP (standard play) - fastest t^e speed (record­
ing time for a T I 2 0 tape is approximately two
hours); best picture quality.
• LP (long play) - average tape speed (recording
time for a T I 2 0 tape is approximately four
hours).
• SLP (super long play) - slowest tape speed
(recording time for a T 1 2 0 tape is approximately
six hours).
Tint adjusting changes the tints of the picture on the
TV/VCR from purple to green.
VCR: video cassette recorder.
VIDEO lack: jack located on the front of the
TV/VCR which is used to record video from anoth­
er source.