Philips CCZ192AT - Manual (Page 10)

10 Automatic Channel Setup
Although theTV/VCR may automatically memorize the channels
you receive when you turn it on for the first time, you may set up
channels again by following the steps below.
Wait for the TV/VCR to set up
channels.
I
Press the MENU button.
ADJUST PRESS
> INPUT
EXIT
PRIM. SETUP
VCR PROGRAM
VCR SETUP
CAPTION
pCABLE 1
J
2
Pre^ the PLAYf A button or the STOP/T button to select
INPUT Pr«ss the REW(ind)/-^ button or the F.FWD/^
button until ANTENNA or CABLE (whichever you have)
appears beside INPUT»
/ to ADJUST PRiSS-^/^ ^
> BWT
EXIT
PRIM. SETUP
VCR PROGRAM
VCR SETUP
CAPTION
3
Press the STOP/T button repeatedly to select PRIM.
SETUP, then press the F.FWD/^ button.
PRItiART' SCRIP
> SELECT LANGUAGE
AUTO PROGRAMMING
CH WMOPCr REVie«
VOLUME BAR £ON]
SET CLOCK
SELECT AT CHOOSE»-
TO END PRESS EXIT
4
Press the PLAY/A button or the STOP/T button to select
AUTO PROGRAMMING, then press the F.FWD/P- but­
ton. AUTO PROGRAMMING MEMORIZED CH ...will appear on­
screen. The TV/VCR will memorize all available channels.
I
jBStttB mggf
PHILIPS EUsUa
J
5
Wait for a few minutes. When setup is complete, CHANNELS
ARE SET will appear on-screen.Then the programming of the low­
est channel number placed in theTV/VCR’s memory will appear
on-screen. Now, when you press the CHANNEL A/T buttons,you
will scan only through channels you receive.
Une Input mode mil always be
stored in the TY/VCR’s memory as
channel 00. You cannot delete it
You cannot program channels when
the TV/VCR Is on channel 00 {MV
INPUT will appear beside INPUT at
step 2). Select ANTENNA or CABLE
( I t step 2. ___________