Philips CCZ192AT - Manual (Page 33)

Timer Recording (contVf) 33
4
Use the Number buttons (I - 8) to select a position in
which to store the timer recording. Rashtng numbers indi­
cate an open position (one in which a timer recording has not yet
been stored).
NOTE; If you select a number that has already been used to store a
timer recording, PREVIOUSLY SET PROGRAM will appear onscreen for a
few seconds. Then information about the program in that position will
appear on-screen. If this happens, press the STATUS/EXIT button Then
use the Number buttons to select another position
5
I Enter the channel of the TV program you want to record (you
must enter a 0 before all single-digit channels).
> If you are recording from line input, press 0,0. A/V IN will
appear on-screen.
1 If you are recording using a Cable Box, enter the Cable Box
output channel (03 or 04). Be sure to select the channel of the
TV program at die Cable Box and leave the Cable Box on for
the timer recording.
■' we TIME PROGRAM ^
PROGRAM I
CHANNEL —
TO CORRECT PRESS CLEAR
^ END PRESS EXrr______________^
6
Press two Number buttons for the hour(s) you want the
recording to begin. Press two Number buttons for the
minute(s) you want the recording to begin. Press I for AM
or 1 for PM. For example, for 9:30 PM, press 09,30,2.
^ONETIME PROGRAM
program I
CHANNEL 10
TIME ON —
TO CORRECT PRESS CUAR
TO END PRESS EXTT
7
Follow the instructions in step 6 to set the recording's
stop time. (AM or PM will be set automatically.)
'^ONETIME PROGRAM
PROGRAM I
CHANNEL 10
TIME ON 09*JO PM
TIMEOFP
TO CORRECT PRESS CLEAR
TO END PWSS EXIT
Instructions continue on page 34.
tf the numbers entered do not
motch the TV/VCR's calendar, the
entry will be r^ected and a question
mark wifi appear on-screen.
To make corrections while you are
programming a timer recording,
press the CLEAR button until the
cursor is flashing on the item you
want to change. Then enter the cor­
rect information