Futaba FX-40 - Manual (Page 91)

91
AIL 3
(Chip Aileron)
AIL 4
(Chip Aileron)
AIL1
(Main Aileron)
AIL 2
(Main Aileron)
FLP 2
(Camber Flap)
FLP 1
(Camber Flap)
ELEVATOR
ELEVATOR 2
V-TAIL
ELEVATOR ELEVATOR 2
AILEVATOR
FLP 3
(Brake Flap)
FLP 4
(Brake Flap)
6HWWLQJPHWKRG
ŏ7RXFKWKH,1+EXWWRQDQGVHWWKHIXQFWLRQWR$&7
21
ŏ:KHQVHWWLQJDVZLWFKWRXFKWKH>18//@EXWWRQ
to call the screen, and then select the
VZLWFKDQGVHWLWV21GLUHFWLRQ$OZD\V21DW
18//VHWWLQJ
(For a description of the switch selection method,
see the description at the back of this manual.)
ŏ:KHQVHWWLQJDFRQGLWLRQGHOD\WRXFKWKH
&RQGLWLRQ'HOD\EXWWRQDQGVHWWKHGHOD\ZLWKWKH
adjustment buttons which appear on the screen.
7KH95RSHUDWLRQPRGHFDQDOVREHVHW
(For a description of condition delay, see the
description at the back of this manual.)
ŏ&DPEHU$)5'5VFUHHQFDOO
7RXFKWKH&DPEHU$)5EXWWRQWRFDOOWKHVHWXS
screen. (For a description of the setup method,
see the description at the back of this manual.)
&XUYHUDWHVHWXSVFUHHQ
ŏ7KHFXUYHDQGUDWHDUHDGMXVWHGE\FDOOLQJWKH
DLOHURQÁDSDQGHOHYDWRUFXUYHUDWHVFUHHQV
The rate and curve of each servo can be set by
calling each screen. (For a description of the
curve setting method, see the description at the
back of this manual.)
The servo speed can also be adjusted.