Futaba FX-40 - Manual (Page 59)

59
Frequency setting
The FX-40 transmitter uses a synthesizer system.
Its frequency can be changed within the range of
the frequency band of the module used.
The frequency of the R5014DPS receiver is set
from the transmitter. Use a receiver matched to the
frequency band of the transmitter.
Receiver ID code
W h e n t h e R 5 0 1 4 D P S r e c e i v e r ( P C M - G 3
receiver) is used, the ID code located on the back
of the receiver case must be entered.
*When two receivers are used with a large model, etc., enter
the 2nd receiver ID also.
ŏ5HWXUQWR/LQNDJH0HQX
ŏ7RXFKWKH>)UHTXHQF\@EXWWRQLQWKH/LQNDJH
0HQXWRFDOOWKHVHWXSVFUHHQVKRZQEHORZ
Frequency
)UHTXHQF\%DQGVHWWLQJPRGXODWLRQPRGHVHWWLQJUHFHLYHU,'FRGHVHWWLQJ
Frequency switching method
For a description of the frequency switching and
ID setting methods, refer to the procedure given in
the Basic Operation section.
Modulation mode change
7RXFK WKH 0RGXODWLRQ 0RGH EXWWRQ WR FDOO
WKH VHOHFWLRQ VFUHHQ DQG WKHQ WRXFK WKH
EXWWRQRIWKHW\SHRIPRGXODWLRQXVHG
7RXFKWKH>(QWHU@EXWWRQWRVZLWFKWKHPRGH
*When switching from the PCM-G3 mode to another mode,
the mode cannot be switched if the number of channels is
LQVXI¿FLHQWGXHWRWKHZLQJW\SHXVHG
330PRGXODWLRQ
7KH DGGLWLRQDO GLDORJ ER[ DSSHDUV ZKHQ
VHW WKH 330 PRGXODWLRQ 3XVK WKH XSSHU
VLGH EXWWRQ WR VHOHFW WKH 330 SRODULW\ 7KH
6WDQGDUG 330 FRUUHVSRQGV WR )87$%$
Modulation mode selection
With the FX-40, 3 modulation modes (PCM-G3/
PCM1024/PPM (FM)) can be selected. Select the
modulation mode matched to the type of receiver
used.
>3&0FKPRGH@
7KH'*EXWWRQLVDGGHGRQWKHIXQFWLRQ
PHQXDWWKH3&0PRGH
&DXWLRQ7KHFXUUHQWFKUHFHLYHUPXVWEH
PRGLÀHGDWWKHVHUYLFLQJGHSDUWPHQWWR
HIIHFWLYHWKHWKFKDQQHO
UHFHLYHUV3XVKORZHUVLGHEXWWRQWRVHOHFWWKH
330FKDQQHOV7KHUHDUHNLQGVRIVHOHFWLRQV
FK330FK3301FK3301
1PHDQVQHXWUDOSXOVHZLGWK
Receiver ID code input
7RXFKWKHUHFHLYHU,'1RRQWKHVFUHHQ7KH
UHFHLYHU ,' VHWXS VFUHHQ LV GLVSOD\HG ,QSXW
WKHGLJLW,'QXPEHUGLVSOD\HGRQWKHEDFN
FDVHRIWKHUHFHLYHU
,IWKH,'QXPEHULVFRUUHFWWRXFKWKH>(QWHU@
EXWWRQ 7R FRUUHFW WKH QXPEHU XVH WKH >%6@
EXWWRQ DQG FKDQJH WKH QXPEHU WR WKH
FRUUHFW,'FRGH
*Once the ID code is set, it does not have to be set again as
long as the receiver is not changed.
WARNING
:KHQÀ\LQJDIWHUIUHTXHQF\FKDQJHHPLWUDGLR
waves only after verifying the frequency.
*Also change the frequency clip. Emitting radio waves with-
RXWYHUL¿FDWLRQLVH[WUHPHO\GDQJHURXV