Futaba FX-40 - Manual (Page 51)

51
FUNCTIONS OF LINKAGE MENU
The Linkage Menu is made up of functions
which perform model addition, model type
selection, frequency setting, end point setting, and
other basic settings.
ŏ5HWXUQWR+RPHVFUHHQ
ŏ:KHQDEXWWRQLQWKH/LQNDJH0HQXRIWKH+RPHVFUHHQ
LV WRXFKHG WKH PHQX VKRZQ EHORZ LV FDOOHG 7RXFK WKH
EXWWRQRIWKHIXQFWLRQ\RXZDQWWRVHW
The functions which can be selected depend on
the model type. A typical menu screen is shown
below.
(The display screen is an example. The screen depends on the model type.)
Linkage Menu functions table
[Servo Monitor]: Displays the servo test and operation position
[Model Select]: Model addition, call, deletion, copy, model name setting
[Model Type]: Model type, wing type, tail type
[Picture]: Picture selection for each model
[Sound]: Sound recording and playback
[Frequency]: Frequency selection, modulation mode selection, receiver ID setting
[Function]: Channel assignment of each function can be changed
[Sub-Trim]: Adjusts the neutral position of each servo
[Servo Reverse]: Servo direction reversal
[Fail Safe]: Fail safe function and battery fail safe function setting
[End Point (ATV)]: Servo basic rudder adjustment and limit setting
[Throttle Cut]: Stops the engine safely and easily (airplane and helicopter only)
[Idle Down]: Lowers the idle speed of the engine (airplane and helicopter only)
[Swash]: Swash AFR and linkage correction function (helicopter only)
[Timer]: Timer setting and lap time display
[Dial Monitor]: Dial, sliding lever, and digital trim position display
[Data Reset]: Model memory set data reset (by item)