Futaba FX-40 - Manual (Page 106)

106
Snap Roll
>&RUUHVSRQGLQJPRGHOW\SH@$LUSODQHJHQHUDO
This function selects the switch and rate
adjustment of rudder, ailerons, elevators, or flaps
when a snap roll is performed.
ŏ)RXUVQDSUROOGLUHFWLRQVFDQEHVHW5LJKWXS
right/down, left/up, left/down)
ŏ2SHUDWLRQPRGH:KHQ>0DVWHU@PRGHLVVHOHFWHG
WKH6QDS5ROOIXQFWLRQLVWXUQHG212))E\PDVWHU
switch in the state in which the direction switch
was switched to the direction in which you want
WRVQDSUROO:KHQ>6LQJOH@PRGHLVVHOHFWHGVQDS
roll in each direction can be executed by means
of independent switches.
ŏ$VDIHW\VZLWFKFDQEHVHW$VDVDIHW\PHDVXUH
the switch can be set so that snap roll is not
executed when, for instance, the landing
gear is lowered, even if the switch is turned on
accidentally. The snap roll switch is activated only
ZKHQWKHVDIHW\VZLWFKLV21
ŏ7KHRSHUDWLRQVSHHGRIWKHDLOHURQHOHYDWRUDQG
ÁDSVHUYRVFDQEHDGMXVWHGIRUHDFKVQDSUROO
GLUHFWLRQ,QVLGH2XWVLGH3DJH
([DPSOH6HWWLQJH[DPSOHIRU)$
ŏ0RGH>0DVWHU@
ŏ6DIHW\6:>6:*@6DIHW\PHDVXUH
ŏ 0 D V W H U 6 : > 6 : + @ 0 D L Q V Z L W F K I R U
executing snap roll)
ŏ'LUHFWLRQVZLWFKHV
*The snap roll up side left and right and down side left and right
direction switches are selected here.
5LJKW8S2))>6:'@
5LJKW'RZQ2))>6:'@
/HIW8S2))>6:$@
/HIW'RZQ2))>6:$@
ŏ6SHHGDGMXVWPHQW6FUHHQ
The operation speed of each control
VXUIDFH ZKHQ WKH VQDS VZLWFK LV 21 FDQ
be changed and snap roll executed by
stick while there is switch operation can be
performed.
ŏ 7RXFK WKH >6QDS 5ROO@ EXWWRQ LQ WKH 0RGHO
0HQX WR FDOO WKH VHWXS VFUHHQ VKRZQ
below.
ŏ5HWXUQWR0RGHO0HQX
ŏ&XUYHGLVSOD\PRGHVZLWFKLQJ
(Single/Fine tuning/All Cond.)
ŏ *URXSVLQJOH PRGH VZLWFKLQJ
(Gr./Sngl)
(For more information, see the description
at the back of this manual.)
ŏ5DWHDGMXVWPHQWRIHDFKUXGGHU ŏ'LUHFWLRQVZLWFKHV
ŏ$GMXVWPHQWRIWKHVHUYRVSHHGRIHDFKUXGGHU
(For a description of the setting method, see the description at the back of this manual.)