Futaba FX-40 - Manual (Page 82)

82
AIR BRAKE
AIL 3
(Chip Aileron)
AIL 4
(Chip Aileron)
AIL1
(Main Aileron)
AIL 2
(Main Aileron)
FLP 2
(Camber Flap)
FLP 1
(Camber Flap)
ELEVATOR
(ELEVATOR 2)
V-TAIL
AILEVATOR
FLP 3
(Brake Flap)
FLP 4
(Brake Flap)
RUDDER 2
Winglet
RUDDER 1
RUDDER
(RUDDER 2)
Winglet
at Flying wing at Flying wing
( ) ( )
ELEVATOR ELEVATOR 2
(AILERON 5) (AILERON 6)
Ɣ&DPEHU0L[
Adjusts the camber and corrects the elevators.
[Airplane/glider, 2 ailerons or more]
Ɣ(/(WR&DPEHU
8VHGZKHQ\RXZDQWWRWKHPL[FDPEHUÁDSVZLWK
elevator operation. Lifting force can be increased
at elevators up. [Airplane/glider, 2 ailerons or more]
Ɣ&DPEHU)/3WR(/(
Used to correct for attitude changes when the
FDPEHUÁDSVDUHEHLQJXVHG>$LUSODQHJOLGHU
DLOHURQVÁDSRUPRUH@
Ɣ%XWWHUÀ\&URZ
Used when powerful brake operation is necessary.
[Glider, 2 ailerons or more]
Ɣ7ULP0L[
7KHDLOHURQVHOHYDWRUVDQGÁDSVWULPRIIVHWUDWHFDQ
be called by switch or condition selection. [Glider, 2
ailerons or more]
Ɣ$LUEUDNH
This is used when airbrakes are necessary when
ODQGLQJRUZKHQGLYLQJHWFGXULQJÁLJKW$LUSODQH
general)
Ɣ*\UR
This is dedicated mixing when a GYA Series gyro is
used. [Airplane/glider, general]
Ɣ9WDLO
Adjusts the elevators and rudder of V-tail models.
>$LUSODQHJOLGHU9WDLOVSHFLÀFDWLRQV@
Ɣ$LOHYDWRU
Adjusts the elevators and ailerons of models with
HOHYDWRUVSHFLÀFDWLRQV>$LUSODQHJOLGHUHOHYDWRU
VSHFLÀFDWLRQV@
Ɣ:LQJOHW
Adjusts the left and right rudders of winglet models.
>$LUSODQHJOLGHUZLQJOHWVSHFLÀFDWLRQV@
Ɣ0RWRU
The operation speed when the motor of F5B and
other EP gliders is started by switch can be set. [EP
glider, general]
Ɣ58'WR(/(
This is used to correct roll maneuvers, knife edge,
etc. of stunt planes. [Airplane, general]
Ɣ6QDSUROO
This selects the snap roll switch and adjusts the
steering angle of each rudder. Servo speed can
also be adjusted. [Airplane general]
Ɣ0XOWL(QJLQH
This adjusts the throttles independently when using a
PXOWLHQJLQHPRGHO0D[LPXPHQJLQHV>$LUSODQH
general]