Futaba FX-40 - Manual (Page 113)

113
Normal Curve Idle-up 1 Curve Idle-up 2 Curve
Ɣ7KURWWOH&XUYH([DPSOH
The curves shown below were created by using
the Line mode and entering the data of the 5 points
0% (low side), 25%, 50% (center), 75%, 100%
(high) side at each condition. They were created by
reducing the number points of the line to 5. When
actually creating a curve, enter the data specified
per the fuselage (or the reference value).
*For a description of the curve creation method, see the
description at the back of this manual.
Curve setting examples
ŏ5HWXUQWR0RGHO0HQX
Throttle Hover trim
The Throttle Hover trim setup screen can be called from the THR Curve setup screen.
ŏ6HWV7KURWWOH+RYHUWULP
ŏ6HWVWKHGLDOXVHG
The Throttle Hover function trims the throttle
near the hovering point. Normally, use it with
hovering conditions. Changes in rotor speed
accompanying changes in the temperature,
humidity, and other flight conditions can be
trimmed. Adjust the throttle so that rotor rotation is
most stable. More delicate trimming is also possible
by using this function along with the Hover Pitch
function.
Setting method
ŏ:KHQXVLQJWKHKRYHULQJQRUPDOFRQGLWLRQ
RQO\VZLWFKWKH>*U@JURXSEXWWRQPRGHWRWKH
>6QJO@VLQJOHPRGHDQGPDNHWKHVHWWLQJV
ŏ6HWWKHIXQFWLRQWR$&7>21@
ŏ6HOHFWWKHDGMXVWPHQWNQRE6HOHFWLRQH[DPSOH5'
ŏ7KHWULPRSHUDWLRQPRGH0RGH&7501250
FDQEHVHOHFWHG
CTRM mode:
0D[LPXPUDWHRIFKDQJHQHDU
FHQWHUE\FHQWHUWULPRSHUDWLRQ
NORM mode:
1RUPDOWULPKRUL]RQWDOPRYHPHQW
WULPRSHUDWLRQ7KHDGYDQWDJHRIXVLQJWKLVPRGH
LVWKDWKRYHULQJWKURWWOHFDQEHDGMXVWHGZLWKRXW
FKDQJLQJWKHFXUYH
ŏ7ULPDGMXVWPHQWUDQJH5DQJHVHWWLQJ
:KHQWKHYDOXHLVPDGHVPDOOWULPDFWVRQO\QHDU
WKHFHQWHU
ŏ7KHWULPUDWHFDQEHDGMXVWHGDQGWKHRSHUDWLRQ
GLUHFWLRQFDQEHVHW