Futaba FX-40 - Manual (Page 80)

80
6HWWLQJPHWKRG
&750 PRGH Maximum amount of change
near center by center trim operation. When the
adjustment range (Range) value is made small, trim
is active only near the center.
1250PRGH Normal trim (parallel movement
trim) operation. When the adjustment range (Range)
value is made small, trim is active only near the
center. Needle high trim works as high trim based
on the center. This operation is similar to reverse
ATL trim.
$Q DFFHOHUDWLRQ IXQFWLRQ FDQ EH VHW 7KLV
function is used when there are symptoms
of the mixture being either too rich or
too lean, which would be generated by
VXGGHQ RSHUDWLRQ RI WKH WKURWWOH VWLFN
$Q DFFHOHUDWLRQ $&/5 IXQFWLRQ DQG
G H F H O H U D W L R Q ' & / 5 I X Q F W L R Q Z K L F K
temporarily increase and decrease the fuel
supply at acceleration and deceleration,
can be set.
7KHUHWXUQWLPHDIWHURSHUDWLRQ'XPSFDQ
EHVHWIRUERWKVHWWLQJDWDFFHOHUDWLRQ+LJK
and setting at deceleration (Low).
$QHHGOHWKURWWOHFXWIXQFWLRQFDQEHVHW
2SHUDWLRQ OLQNHG ZLWK WKH WKURWWOH KROG
IXQFWLRQV&XWDQG,GOH7KURWWOH&XWIXQFWLRQ
DQG,GOH'RZQIXQFWLRQLVSRVVLEOH
7KHQHHGOHVLGHFXWSRVLWLRQFDQEHVHW6HWLW
to the fuel side full open position.
:KHQ WKH MIX mode is selected, the throttle
curve set data becomes the mixing master.
In the UNMIX
PRGH WKH WKURWWOH VWLFN SRVLWLRQ
becomes the mixing master.
ŏ5HWXUQWR0RGHO0HQX
ŏ7RXFKWKH>)XHO0L[WXUH@EXWWRQLQWKH0RGHO0HQXWR
call the setup screen shown below.
)XHO0L[WXUH 0L[LQJXVHGLQQHHGOHDGMXVWPHQWRIHQJLQHVZKLFKXVHDIXHOPL[WXUHFRQWURO
FDUEXUHWRU>$LUSODQHKHOLFRSWHU@
This function is dedicated mixing used in needle
adjustment of an engine that uses a fuel mixture
control carburetor.
*The needle channel is assigned to CH9 as a default.
ŏ2SHUDWLRQFXUYHVHWWLQJ
(For a description of the setting method, see the description at the
back of this manual.)