Futaba 8J User Manual
Page 70
69
GOAL of EXAMPLE:
STEPS:
INPUTS:
Set up a RUDD-ELEV curve mix on a
model that pitches down severely at
full rudder and not at all with minimal
rudder input, and pitches worse on right
rudder than left:
P-1: 25%
P-2: 8%
P-3: 0%
P-4: 10%
P-5: 28%
ON
when SWITCH C is down.
1RWH WKDW SRLQW LV 2WKHUZLVHWKH
elevator would be retrimmed when the
mix is active and no rudder input is
given.)
Open an unused curve programmable
mix. (Ex: use PROG.MIX6 since it is
DOUHDG\ VHWXS IRU RUDDER-ELEV.)
for 1 second.
to P.MIX1-6.
to 6.
Activate the function.
to MIX.
to ON.
Choose master and slave channels.
(Ex: do not change MAS or SLV).
already RUDD
already ELEV
Assign SWITCH and position.
(Ex: change to C, DOWN.)
to SW.
to C.
to POSI.
to DOWN.
Optional: set switch to THR to activate
mix with THROTTLE STICK. (See
above for details.)
to SW.
to THR.
to POSI.
THROTTLE STICK to desired
point.
for 1 second to set.
Optional: set switch position to NULL
0DNHV PL[ DFWLYH DW DOO WLPHV 1RW
FRPSDWLEOH ZLWK THR
to POSI.
to NULL.
6HW GHVLUHG SHUFHQW DW WKH VWLFN SRLQWV
(Ex: listed at left.)
to P-1.
to 25%.
5HSHDW IRU SRLQWV
Close menu.
Where next?
Adjust servo END POINTs: see p. 36.
Set up AILEVATOR: see p. 54.
9LHZ QXPHURXV PL[ VHWXSV ZZZIXWDEDUFFRP?IDT?