Futaba 8J User Manual
Page 33
32
Adjustable travel limit (ATL PDNHV WKH FKDQQHO TRIM LEVER (THROTTLE TRIM) effective only at low throttle,
disabling the trim at high throttle. This prevents pushrod jamming due to idling trim changes. This function defaults to ON.
If you are not using channel 3 for throttle, you may want trim operation the same as on all other channels. To do so, set ATL
to OFF. If you need the ATL WR EH HIIHFWLYH DW WKH WRS RI WKH VWLFN LQVWHDG RI WKH ERWWRP UHYHUVH WKH THR-REV setting. Note
that this affects all models in the radio, not just the model you are currently editing. THR-REV, see p. 92.
GOAL of EXAMPLE:
STEPS:
INPUTS:
Change ATL from ON to OFF for battling
URERWV WDQNV DLUEUDNHV DQG RWKHU
channel 3 uses.
Open the menu, then open PARAMETER
submenu.
for 1 second.
to PARAMETER.
Go to ATL and Change. (Ex: to OFF)
to ATL.
to OFF.
Close.
Where next?
Set up ELEVON IRU WDQNVW\OH FRQWURO WKURWWOHVWHHULQJ RQ RQH 67,&. VHH S
Set up IDLE-DOWN and THR-CUT WR DGMXVW FKDQQHO VHUYR DW ORZVWLFN VHH S
5HDVVLJQ DX[LOLDU\ FKDQQHOV H[ IURP GLDO WR VZLWFKVOLGHU VHH S
Utilize servo REVERSE: see p. 35.
Adjust servo travel with END POINT: see p. 36.
Set up dual/triple rates and exponential(D/R,EXP): see p. 39.
LCD screen adjustment (CONTRAST/BACK-LIT/LIT-TIME/LIT-ADJS):
Adjustability:
The following LCD screen adjustments are possible.
&RQWUDVW DGMXVWPHQW
%DFNOLJKWLQJ PRGH
%DFNOLJKWLQJ WLPH
%DFNOLJKWLQJ EULJKWQHVV DGMXVWPHQW
GOAL of EXAMPLE:
STEPS:
INPUTS:
Change CONTRAST from 0 to +2.
Open the menu, then open PARAMETER
submenu.
for 1 second.
to PARAMETER.
Go to CONTRAST and change setting.
(Ex: +2)
to CONTRAST.
to +2.
Close.