Futaba 8J User Manual

Page 32

Receiver modulation select (RX): sets the type of modulation transmitted.
The modulation of your receiver will determine whether you utilize S-FHSS or FHSS setting in RX during transmission.
1RWH WKDW \RX KDYH WR WXUQ \RXU WUDQVPLWWHU RII DQG EDFN RQ EHIRUH D PRGXODWLRQ FKDQJH EHFRPHV HIIHFWLYH %H VXUH \RX
XQGHUVWDQG DQG VHW WKH )DLO6DIH F/S ) settings as you intended (see p. 48).

S-FHSS

/FHSS 6)+66)+66*+] V\VWHP S-FHSS mode/FHSS mode)

Adjustability:
S-FHSS VHWWLQJ IRU DOO )XWDED 6)+66* PRGH UHFHLYHUV UHJDUGOHVV RI

number of channels.

FHSS VHWWLQJ IRU DOO )XWDED )+66* PRGH UHFHLYHUV UHJDUGOHVV RI QXPEHU

RI FKDQQHOV ,W RSHUDWHV RQO\ IURP &+ WR &+ $V IRU )6 RQO\ &+

NOTE: When you change models in MODEL SELECT, if the new model is set to the other modulation type,
\RX PXVW F\FOH WKH WUDQVPLWWHU SRZHU WR FKDQJH PRGXODWLRQV 7KH PRGXODWLRQ ZLOO ÀDVK RQ WKH KRPH VFUHHQ
to remind you until you do so. See p. 27, MODEL SELECT, for details.

Use

R2008SB

S-FHSS

mode. Because,

FHSS

has channel restrictions.

GOAL of EXAMPLE:

STEPS:

INPUTS:

Change model 1 from S-FHSS to FHSS.

Confirm you are currently using the
proper model memory (Ex: 1)

2Q KRPH VFUHHQ FKHFN PRGHO QDPH DQG
number on top left and the modulation
on top right. If it is not the correct
model, use MODEL SELECT, p. 27.

Open the menu, then open PARAMETER
submenu.

for 1 second.

to PARAMETER.

Go to RX and change setting.

to RX.

to FHSS.

cycle power

ÀDVKHV RQ VFUHHQ

Cycle power.

Where next?

Now that the model is in the proper modulation, the T8J should communicate
ZLWK WKH UHFHLYHU ,I LW GRHV QRW FRQ¿UP WKH W\SH RI WKH UHFHLYHU
Change MODEL TYPE to airplane/helicopter: see p. 30.
Set F/S settings for when 2.4G receiver sees interference: see p. 48.
Utilize servo REVERSE: see p. 35.
Adjust servo travel with END POINT: see p. 36.
Set up dual/triple rates and exponential (D/R,EXP): see p. 39.