Futaba 8J User Manual
Page 48
47
The servo submenu includes two features:
Real-time bar-graph display to demonstrate exactly what commands the
transmitter is sending to the servos. (This can be particularly handy in setting
up models with complicated mixing functions, because the results of each
VWLFN OHYHU NQRE VZLWFK LQSXW DQG GHOD\ FLUFXLW PD\ EH LPPHGLDWHO\ VHHQ
Servo cycle function WR KHOS ORFDWH VHUYR SUREOHPV SULRU WR LQÀLJKW IDLOXUHV
FKDQQHOV
Adjustability:
&DQ FKRRVH servos to be cycled.
&\FOH W\SH /15/LQHDU PRGH-03-XPS PRGH
&\FOH WR VORZ GHIDXOW
6HUYR VSHHG WR IDVW GHIDXOW
7KH VHUYR FKHFNHG KHUH >Ŷ@ FDUULHV RXW WHVW RSHUDWLRQ DW WKH WLPH RI 3RZHU
'RZQ 0RGH H[FHSW IRU &+ 7KLV LV IRU D GLVWDQFH FKHFN
GOAL of EXAMPLE:
STEPS:
INPUTS:
9LHZ WKH UHVXOW RI UHDVVLJQLQJ FKDQQHO
6 from VR NQRE WR WKUHHSRVLWLRQ
SWITCH C.
C o m p l e t e d e s i r e d p r o g r a m m i n g
function. (Ex: in AUX-CH, move ch. 6 to
SWITCH C)
See AUX-CH for details. (p. 43.)
Open the SERVO function.
for 1 second.
to SERVO.
Move each control to see the operation.
(Ex: SWITCH C in all positions)
C to center position.
Note change in position of ch. 6 servo.
Cycle the channel 6 servo.
Prepare servos to be cycled.
Plug in servos. POWER ON.
Open the servo cycle function.
to GRAF>.
Set up cycle mode. (Ex: JMP mode)
to TYPE.
to JMP.
Choose channels to be cycled. (Ex: ch. 6)
to CH6.
to ACT.
Cycle the channel 6 servo.
to TEST.
End cycling and close.
Where next?
Set up dual/triple rates and exponential (D/R,EXP): see p. 39.
Set up desired programmable mixes: see p. 65.
Set up dual aileron servos: see p. 52.
Set up dual elevator servos: see p. 54.
SERVO
display and cycle submenu: GLVSOD\V UDGLRV RXWSXW WR FKDQQHOV