Futaba 8J User Manual
Page 62
61
GOAL of EXAMPLE:
STEPS:
INPUTS:
Activate AIRBRAKE on a FLAPERON.
model. Adjust the flaperon travel to
75%
,with negative elevator (push) of
25%
.
&RQ¿UP FLAPERON is active.
see FLAPERON instructions.
Open the AIRBRAKE function.
for 1 second.
to AIRBRAKE.
Activate the function.
Switch C in up position.
to MIX.
to OFF.
SW selection.
A position is turned ON by down with a
center.
to SW.
to SWC.
to DOWN.
to CT&DN.
Adjust the travels as needed.
(Ex:Ailerons each 75%, Elevator -25%.)
to AIL1.
to 75%.
to ELEV.
to -25%.
to FLAP.
to 75%.
2 S W L R Q D O G H O D \ K R Z T X L F N O \ W K H
elevator servo responds.
WR GHOD\ELEV.
to 25%.
Optional: change the mixing from full
amount upon switch to proportional to
the THROTTLE STICKV SUR[LPLW\ WR
idle.
to MODE.
to LINR (0%).
to 0%.
THROTTLE STICK to desired
point.
for 1 sec, until beeps
(display changes if new setting is different from prior
setting).
Close menu.
Where next?
$GMXVW ÀDSHURQV WRWDO ÀDS WUDYHO DYDLODEOH FLAPERON): see p. 50.
Set up ELE-FLAP mixing: see p. 59.
9LHZ DGGLWLRQDO PRGHO VHWXSV RQ WKH LQWHUQHW ZZZIXWDEDUFFRP?IDT?