Futaba 8J User Manual
Page 68
67
GOAL of EXAMPLE:
STEPS:
INPUTS:
Set up a FLAP-ELEV mix:
ON
when SWITCH C is in the down
position.
1R HOHYDWRU PRYHPHQW ZKHQ ÀDSV PRYH
up (spoilers),
HOHYDWRU PRYHPHQW ZKHQ IODSV
move down,
)ODS KDV QR WULP OHYHU VR TRIM is not
DQ RSWLRQ
Open an unused programmable mix.
(Ex: use P.MIX3 VLQFH LW LV DOUHDG\ VHWXS
for FLAP-ELEVATOR.)
for 1 second.
to P.MIX1-6.
to 3
Activate the function.
to MIX.
to ON.
Choose master and slave channels.
(Ex: no need to change MASTER/SLAVE.)
already FLP
already ELE
2SWLRQDO VHW 0DVWHU DV OFS, DT5, DT6 or
VR
6HH DERYH IRU GHWDLOV
t o MASTER.
t o d e s i r e d
choice.
Set TRIM as needed.
(Ex: leave TRIM not available.)
Assign SWITCH and position.
(Ex: change to C, DOWN.)
to SW.
to C.
to POSI.
to DOWN.
Optional: set switch to THR to activate
PL[ ZLWK THROTTLE STICK 6HH
DERYH IRU GHWDLOV
to SW.
to THR.
to POSI.
THROTTLE STICK to desired
point.
for 1 second to set.
Optional: set switch position to NULL
0DNHV PL[ DFWLYH DW DOO WLPHV 1RW
FRPSDWLEOH ZLWK THR
to POSI.
to NULL.
Set rates. (Ex: Lo=0% +L 5%.)
to RATE.
VR past center. Leave at 0%.
VR past center.
to 5%.
Set OFFST, if needed. (Ex: 0.)
to OFFST. Leave at 0%.
Close menu.
Where next?
Adjust servo END POINTs: see p. 36.
Setup dual/triple rates and exponential (D/R,EXP): see p. 39.
Set up additional programmable mixes, ex: RUDDERAILERON: see p. 65.
9LHZ QXPHURXV DGGLWLRQDO PL[ VHWXSV ZZZIXWDEDUFFRP?IDT?
2WKHU ([DPSOHV
RUD-ELEV (ACRO) mix: Compensate for pitching up or down when rudder is applied.
AIL-RUD (ACRO): Coordinate turns by applying rudder automatically with aileron input. All model types.
ELEV-PIT (HELI) mix: compensate for the loss of lift of tilting the model.